top of page

Navimow X4 Cutting Discs

A genuine left and right disc set for the X430, X450 and Terranox with the blades already installed, so you can restore a clean, balanced cut in one service. $159 from an authorized Navimow service center.

lp-cutting-discs-hero.jpg

★★★★★ Owners on the titanium upgrade

“These discs are great! They greatly speed up blade changes, as you now only have to remove the 4 screws on each protective plate and install the blades, rather than remove each disc, take the disc apart and remove the screw for each blade. They also improve the cut, likely due to the increased number of blades all at the same level, the slightly longer blade length and the slightly angled cutting edge. Highly recommend!” — S. Shaver, verified buyer of our 14-blade titanium discs

The Cutting Discs (blades installed) guide

This is a genuine Segway Navimow left and right cutting disc set with fresh blades already installed, new screws torqued correctly. You swap two discs instead of twelve blades and twelve screws, which saves 20 to 30 minutes and removes the risk of over-tightening. It fits the X430, X450 and both Terranox models.


Navimow blade replacement: how often, how to


When it's time for new discs

  • Blades are due: about every 180 hours of mowing. A fresh pre-built disc set is the fastest way to do it.

  • A new vibration or scalped-looking stripes: a cracked, warped or chipped disc throws off the balance and loads the cutting motors. No amount of blade swapping fixes a bent disc.

  • Hits from sticks, stones, roots and sprinkler heads add up over a season. Discs are a wear item.

  • Replace both at once. They wear at the same rate, and a mismatched pair means a second service soon after.


Removing a cutting disc from a Navimow X4 with a screwdriver
Swapping a disc on an X4.


Swapping them

  1. Turn the mower off, lay it on a soft surface and wear gloves.

  2. Take off the old discs (left part AB.12.06.00.0160, right AB.12.06.00.0161), following the video above.

  3. Fit the new ones to the matching sides and spin each by hand to check it turns freely.

  4. Dispose of the old blades as sharps: tape them together or put them in a rigid container before the trash.



Keeping the cut clean between swaps

  • Clean the deck when clippings pack in: how to clean your Navimow.

  • Mow dry, in the late-morning-to-evening window. Wet grass clumps and dulls blades faster.

  • Cut evenly: if the lawn looks patchy, start with blades and discs, then work through 7 fixes for an uneven cut.

  • Want 50% more cutting edge? Each disc has three spare blade slots: the 18-blade setup.


Can you add more blades to a Navimow? Yes, 18 of them

The underside of a Navimow Terranox showing its two cutting discs
The Terranox uses the same discs as the X4.


Which disc is right for you?



Works with these discs



Cutting disc questions we hear most

Can I sharpen the blades instead?

No. They're thin, cheap and disposable, and sharpening changes the balance. An unbalanced disc vibrates and wears out bearings.

Do I need new screws?

Yes, every time you change blades. The screw is the part that wears where the blade pivots. These discs come with new screws already installed.

Do these fit the Terranox?

Yes. The X430, X450, Terranox 3 Acre (CM120M1) and Terranox 6 Acre (CM240M1) all use this disc set.



More Zippy Lawnz product guides


Robot mowers

Snow

Docking, power and gates

Blades, discs and cut quality

Antenna and signal



Why buy Navimow parts from Zippy Lawnz

We are an authorized Segway Navimow dealer and service center, not a warehouse. We install and repair these mowers ourselves, so we can tell you exactly what fits yours. Not sure? Call or text 410-725-7500 and a real person will answer. Every owner also gets free monthly live training.

Blades and discs for your Navimow

More Zippy Lawnz best sellers

The mowers and parts our customers order most, each one sold, set up and supported by Zippy Lawnz.

Zippy Delmarva
elizabeth@zippylawnz.com
call or text 410-226-6705 

Zippy PA, NJ & DE
paul@zippylawnz.com
call or text 410-725-7500

Zippy Cape Charles, VA
zippy@zippylawnz.com
call or text 410-725-7500

Zippy West
wgolde@zippylawnz.com
call or text 720-251-1446

Zippy Steamboat
matthew@zippylawnz.com
call or text 610-585-6879

  • Reddit
  • Instagram
  • Facebook
  • Youtube
bottom of page