top of page

14-Blade Titanium Cutting Discs

Our best-selling part. An upgrade for the X430, X450 and Terranox: seven hardened, titanium-coated blades per disc for a cleaner cut, and blade changes with 4 screws instead of 12. $159 with blades installed.

lp-titanium-discs-hero.jpg

★★★★★ What owners say

“THE set of upgraded cutting discs for the X4 & Terranox series mowers! These discs are great! They greatly speed up blade changes, as you now only have to remove the 4 screws on each protective plate and install the blades, rather than remove each disc, take the disc apart and remove the screw for each blade. They also improve the cut, likely due to the increased number of blades all at the same level, the slightly longer blade length and the slightly angled cutting edge. Highly recommend!” — S. Shaver, verified buyer

The 14-Blade Titanium Cutting Discs guide

These discs replace the two stock cutting discs on a Navimow X4 or Terranox with a lighter design that carries seven blades each, 14 in all, and changes blades with four screws instead of twelve. They're made in the USA and they're one of our best sellers. Here's what they do, how to fit them, and how to keep them cutting.



What's different from the stock discs

  • 14 blades instead of 12, seven per disc, and the blades reach farther from the disc for more cutting surface.

  • Four screws per blade change instead of twelve, and you don't have to take both discs off to change blades. The blades slip on and clamp in.

  • About 44% lighter than the stock Segway disc, so less rotating weight on the cutting motors, and slightly quieter.

  • A round damage-avoidance guard that softens the jolt when the disc hits something and keeps grass and debris from jamming the blades.

  • Labeled left and right, with an alignment notch on the hub and guard so it goes on right the first time.

  • Fits the Navimow X4 and Terranox: X430, X450, Terranox 3 Acre and 6 Acre.


★★★★★ "These discs are great! They greatly speed up blade changes... They also improve the cut as well. Highly recommend!" — S. Shaver, verified buyer


Removing a cutting disc from a Navimow X4 with a screwdriver
Disc day on an X4.


Fitting them

  1. Turn the mower off and lay it on a soft surface, deck up. Wear gloves: blades are sharp even when they're dull.

  2. Remove the stock discs. Our blade and disc video below shows the X4 step by step.

  3. Fit the left and right discs to the matching sides, lining up the notch on the hub and guard.

  4. Spin each disc by hand to check it turns freely before you run the mower.

  5. Raise the cutting height a notch for the first few runs, then step back down once you've seen how it cuts. More cutting edge removes grass faster.


Navimow blade replacement: how often, how to


Keeping them sharp

  • Change blades by the hour, not the calendar: about every 180 hours of mowing. That's about a month for a mower that runs six hours a day, or about four months at an hour and a half.

  • Change the whole set at once. Mixed wear unbalances the disc, and vibration wears out bearings.

  • Refills: the Hardened Titanium Replacement Blades are made for these discs.

  • Hardened, not the cheap kind: the blades on these discs are hardened titanium: heat-hardened stainless steel with a titanium coating. When we tested a cheap gold-coated set against stock Segway blades, its thin coating wore through fast and the stock blades held a sharper edge; that verdict is about the cheap kind. Whatever blade you run, the change interval matters more than the coating. Read our blade test.

  • Clean the deck when clippings pack in: how to clean your Navimow.


How to clean your Navimow deck and clear grass clumps

Washing the underside of a robot mower to show a clean deck and sharp blades
A clean deck cuts cleaner.


Titanium discs, stock discs or a fresh set?



Works with these discs



Titanium disc questions we hear most

Do these fit the Terranox?

Yes. The Terranox uses the same cutting discs as the X4, so these fit the X430, X450 and both Terranox models.

How often should I change the blades?

About every 180 hours of mowing, and sooner if the tips look torn. Sandy soil, sticks, acorns and wet grass all shorten it.

Why are they easier to change?

Each disc takes four screws for a blade change instead of twelve, the blades slip on and clamp in, and you can change one disc without removing the other.



More Zippy Lawnz product guides


Robot mowers

Snow

Docking, power and gates

Blades, discs and cut quality

Antenna and signal



Why buy Navimow parts from Zippy Lawnz

We are an authorized Segway Navimow dealer and service center, not a warehouse. We install and repair these mowers ourselves, so we can tell you exactly what fits yours. Not sure? Call or text 410-725-7500 and a real person will answer. Every owner also gets free monthly live training.

Blades and discs for your Navimow

More Zippy Lawnz best sellers

The mowers and parts our customers order most, each one sold, set up and supported by Zippy Lawnz.

Zippy Delmarva
elizabeth@zippylawnz.com
call or text 410-226-6705 

Zippy PA, NJ & DE
paul@zippylawnz.com
call or text 410-725-7500

Zippy Cape Charles, VA
zippy@zippylawnz.com
call or text 410-725-7500

Zippy West
wgolde@zippylawnz.com
call or text 720-251-1446

Zippy Steamboat
matthew@zippylawnz.com
call or text 610-585-6879

  • Reddit
  • Instagram
  • Facebook
  • Youtube
bottom of page